[vdr] Re: SV: CAM support, was Improved CAM support in VDR

[Klaus Schmidinger <Klaus.Schmidinger@cadsoft.de>]

Klaus Schmidinger wrote:
> 
> micael.beronius@telia.com wrote:
> >
> > I tried once more. I now pulled the card and re-seated it. I then got;
> >
> > slot 0  state 0003
> > slot 1  state 0000
> > -->> 00 01 82 01 01
> > -->> 00 01 82 01 01
> > -->> 00 01 82 01 01
> > -->> 00 01 82 01 01
> > -->> 00 01 82 01 01
> > -->> 00 01 82 01 01
> > -->> 00 01 82 01 01
> > -->> 00 01 82 01 01
> > -->> 00 01 82 01 01
> > -->> 00 01 82 01 01
> > -->> 00 01 82 01 01
> >
> >  Micael
> 
> Ok so now the CAM is detected to be "present", but still no response is
> received from it. As I stated in my previous reply I assume the CA_RESET
> is not working...

I guess I just found something here: apparently the parameter to the CA_RESET
ioctl() call is not the slot index, but rather flag word containign a '1' bit for
every slot that shall be reset. Please give the new ftp://ftp.cadsoft.de/vdr/Developer/ci.c
a try, in which I have changed this (there may be lots of "slot 0  state 0001" messages at
stdout, but maybe this change activates the actual CA_RESET, which previously wasn't
executed since the slot parameter was '0').

Klaus
-- 
_______________________________________________________________

Klaus Schmidinger                       Phone: +49-8635-6989-10
CadSoft Computer GmbH                   Fax:   +49-8635-6989-40
Hofmark 2                               Email:   kls@cadsoft.de
D-84568 Pleiskirchen, Germany           URL:     www.cadsoft.de
_______________________________________________________________


-- 
Info:
To unsubscribe send a mail to listar@linuxtv.org with "unsubscribe vdr" as subject.